Synkromotive installed

From 2011-11-04 controller

I was supposed to spend the weekend in Tahoe, but it's snowing, cold, and I've been sick for a few weeks. I'm really not up for it right now, so I stayed home. On the bright side, I spent some quality time in the garage and got the Synkromotive controller installed tonight! Pretty straightforward, the hardest part was actually getting to the reverse light wire. I had to pull out the 12v battery, and battery tray to get down to it.

All the existing high voltage cables worked as is, I really didn't have to move much around at all One motor cable is now on the opposite side of the controller, but the cable length still works fine. It's just routed differently. The controller comes with all the wires pre-attached to a connector, it took a while to sort them all out and figure out what went where, and which ones I don't need. The ones I'm not using I just zip tied out of the way. Not sure what I'll do with them long term, I don't really want to cut them off permanently. The ones I do need, I just went one at a time, and took my time connecting them where they need to go.

Anyway, I don't have the new throttle position sensor yet, so I just wired in the existing two wire potbox that's in the car. Not ideal, but it will work.

With the main pack disconnected, I powered up the controller and hooked it up to a laptop with the Synkro software installed on it. It just plugs into a USB port, the program recognized the controller when it opened up and everything looked alright. The interface is sweet, just simple and easy to use. I set the battery parameters then calibrated the pot box. So far so good! I flipped on the main pack breaker, and went for the full test. Car in neutral, one hand turning on the key, and the other holding the cord to trip the breaker. Key on, the controller's fan hummed for a few seconds then went off. The stats on the computer showed pack voltage was on. I gave it a little throttle, and there was a nice little hum as the motor slowly turned over.

After verifying everything for a little bit, I took it for a test drive. For the initial test I set the battery amps to 300, and the motor also to 300. first thing I notice is that it is SMOOOOTH!!!! Finally, I can drive it like an electric car. After a few blocks, I pulled over and bumped the motor amps up to 500 (battery still at 300). Nice! Much quicker off the line. Drove around like this a while, then decided to really go for it and bump it up to 750a. Just on the motor side, battery was still at 300. Very nice! Spun the wheels a bit in second gear. Definately faster now. In the interest of not doing anything stupid, I called it a night and came back home.

Up and into the driveway (up a hill while turning and transitioning over a driveway, it's been my nemesis for driving smoothly) without drama, I could stop and start at will. I'm liking it already! And this is with the old potbox, should get even better with the new TPS.